Two Hand Pneumatic No-Tie Down Module
The Renco 2 Hand No Tie Down Pneumatic Control Module requires the operator to depress two buttons simultaneously (within one-third of a second) To give a pneumatic output. The output remains ON as long as both buttons are depressed. When the operator's hands are removed the pneumatic output signal is exhausted and the module is reset.Provide your employees with safety.Usually ships within 2 days.Satisfaction guaranteed.
!
REN23
Larger picture

Pneumatic Two Hand No Tie Down Systems

SERIES REN23
GIVES A MAINTAINED OUTPUT SIGNAL WHEN BOTH
BUTTONS ARE PRESSED WITHIN .3 SECONDS AND HELD
Working pressure range 60-100 PSI, 
40 Micron Filtered Dry Nonlubricated air
---
Complete two-hand no-tie-down control with buttons on ends

Pneumatic 2 hand start control

The operator must depress two buttons within .3 seconds for obtain a pneumatic output signal

REN28-SET
Larger picture

Pneumatic Two Hand No Tie Down

Series REN28-SET
SET OF 2 PALM BUTTONS WITH LOGIC, TWO-HAND NO-TIE-DOWN CONTROL.  WORKING PRESSURE RANGE 60-100 PSI, 40 MICRON FILTERED DRY NONLUBRICATED
              
ONE PALM BUTTON GIVES A MAINTAINED OUTPUT SIGNAL
WHEN BOTH BUTTONS ARE PRESSED WITHIN .3 SECONDS AND HELD.
Pneumatic 2 hand start control. Set of push buttons with integral logic module
REN300
Larger picture

Pneumatic Two Hand No Tie Down Systems

SERIES REN300
COMPLETE TWO-HAND NO-TIE-DOWN.  WORKING PRESSURE RANGE 60-100 PSI, 40 MICRON FILTERED DRY NONLUBRICATED AIR

GIVES A MAINTAINED OUTPUT SIGNAL WHEN BOTH
BUTTONS ARE PRESSED WITHIN .3 SECONDS AND HELD
Complete pneumatic no tie down modules